亚洲欧美日韩国产精品专区午夜洪_女人18毛片特级一级免费视频_天天影视亚洲综合在线高清_少妇高潮免费毛片_日本免费网站在线看_暖暖视频在线观看日韩_久久精品亚洲日本筱田优_免费护士一级毛片_精品午夜一区二区三区在_又大又粗又爽的三级小视频

Service hotline:

189-2252-0163(Mr.Su)
137-1221-0475(Mr.Jia)

Q&A

  • Why is the cable tie of nylon binding machine not tight enough

    Pull material speed parameter set too fast, please slow down the speed to try to operate, pull spring is too loose will also lead to not tight enough, please tighten the spring, or pull material wheel clearance is too large, small wheel clearance can be adjusted.

    Date:2023-02-28
  • Why do the ties keep cutting?

    If it is worn, please replace the drawing wheel. Cutter wear will also lead to this situation. If it is cutter wear, it also needs to replace the new cutter, or it is because the CAM of the drawing wheel has high friction force.

    Date:2023-02-28
  • How to adjust the gap of nylon binding machine?

    Please open the cover and see the elastic screws on both sides of the pulling wheel. Loosen the roms first and tighten the screws after adjusting the pulling wheel to the appropriate distance.

    Date:2023-02-28
  • Why can't the cable tie fit into the hole?

    If the parameters are incorrectly adjusted, please restore the parameters retained before delivery, or contact the technician of the manufacturer directly, or replace the cable ties with the previous ones because the cable ties are deformed. Check the cable ties to ensure the quality of the cable ti..

    Date:2023-02-28
  • Why does the vibration plate of nylon tape binding Machine feed slowly?

    The reason is that there is dirt in the vibration disk, the vibration disk is set slowly, and there is too much material in the vibration disk. It is necessary to clean the vibration disk and reset the speed, and part of the material is taken out.

    Date:2023-02-28
  • Why does the vibration plate appear card material?

    Please check whether the vibration disk is properly connected to the machine interface. After the connection is properly connected, tighten the four small fixing screws of the vibration disk to ensure that the vibration disk is full of materials before it starts to work. Nylon cable ties more burr o..

    Date:2023-02-28
Total6Data Page Location1/1Page Home Prev Page 1 Next Page Last Page